Manual T*SOL basic 5.0 - Valentin Software
Manual T*SOL basic 5.0 - Valentin Software
Manual T*SOL basic 5.0 - Valentin Software
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
7 System Definition User <strong>Manual</strong> <strong>T*SOL</strong><br />
2. Select one of the auxiliary heating systems types:<br />
3. Heat pump<br />
4. Continuous-flow water heater<br />
• Gas-fired boiler<br />
• Gas condensing boiler<br />
• Gas-fired boiler (small)<br />
• Oil boiler<br />
• Oil condensing boiler<br />
• Oil-fired boiler (small)<br />
• Wood-fired boiler<br />
• Solid fuel boiler<br />
• Pellet-fired boiler<br />
• District heating<br />
• Combined heat and power station (CHP)<br />
Image: Dialog for boiler<br />
selection<br />
5. Select one of the auxiliary heating systems by clicking it in the list on the right side.<br />
6. Confirm the selection Select. The dialog > Parameters is displayed again.<br />
OR: If you don't know the specific auxiliary heat, you can load the standard auxiliary heat for the<br />
simulation:<br />
- Click on Load standard. The standard rated output is always the same for any given type of system.<br />
OR: Configuration of the output<br />
- Click on Design. This enters correct output for the system and consumption.<br />
- You can accept this output.<br />
7. Set the Operating Times of the boiler:<br />
Click on the month fields to set operation for entire months (green area = boiler in operation).<br />
An annual view can be accessed by clicking on the magnifier , in which you can switch individual days<br />
on and off.<br />
8. Save all entries by clicking OK or go to the next parameter dialog using the arrow button .<br />
Efficiency<br />
System Definition, e.g. System Definition > Gas Boiler > Efficiency<br />
page 69 / 104 Dr. <strong>Valentin</strong> Energie<strong>Software</strong> GmbH
Change language