Manual T*SOL basic 5.0 - Valentin Software
Manual T*SOL basic 5.0 - Valentin Software
Manual T*SOL basic 5.0 - Valentin Software
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
User <strong>Manual</strong> <strong>T*SOL</strong> 7 System Definition<br />
2. the switching temperatures for the auxiliary heating can be changed.<br />
Under Height, the position of the temperature sensor in the tank is displayed.<br />
The switching temperatures are entered in relation to the desired tank temperature.<br />
3. If the checkbox next to With restricted load times is activated, the switching times can be defined<br />
using the clock (green area = tank can be loaded, gray area = tank is not loaded, irrespective of its<br />
operating state).<br />
4. In the Collector Loop Connection section, the position of the measurement sensors for switching on<br />
and off the collector loop and the maximum temperature limit of the tank are displayed. The<br />
maximum temperature limit can be changed.<br />
7.4.2.3 Combination tank<br />
System Definition > Tank or system schematic<br />
Combination tank in tank<br />
System Definition > Tank > Heat Exchanger / Tank<br />
Image: Input dialog for tank in tank<br />
system, Heat Exchanger / Tank page<br />
On the Heat Exchanger / Tank page, the internal tank for supply of hot water volume is defined. The<br />
geometry of the internal tank is displayed only and cannot be changed.<br />
Dr. <strong>Valentin</strong> Energie<strong>Software</strong> GmbH page 64 / 104
Change language