Stand-Alone Punch machine user manual - Finn-Power International ...

Include- When selected all tool hits selected on screen will be added to selected
zone. Interactive Zones will check machine parameters to see if any hits exceed
maximum limitations of the machine for the selected working zone.
Exclude- Selected tool hits will be removed from the selected zone.
Expand- Selected nibble paths will be expanded on screen to give ability to select
specific tool hits within nibble path.
Tool_ID Filter- Selecting Tool_ID filter will call up a screen that lists all tools
used in the current nest. Select tools within this list to only select these tools on
the screen. For example, user wants a square 10mm tool to be removed from the
first zone and placed into the second zone. User will select square 10 tool, then
exclude, select zone 1, and then highlight entire screen (all square 10 tools will be
highlighted for first zone).
Rect Hit Info- Informs user how many tool hits have been selected either bound
(included) or released (excluded).
Plate Hit Info- Displays list of tool hits for entire plate. Shows how many hits are bound
(included) and released (excluded). Released hits should be zero before exiting
Interactive Zones. If tool hits will purposely be left out of a nest, released hits can be
other than zero for all undesired tool hits.
Translation (Add to Clamps)- Enter value mm or inch to be added to all clamps for new
zone.
Pressure Pad Location- Enter value of X,Y coordinate where center location of
reposition pads will be (RAM location).
Clamp Locations- Enter values for each clamp to adjust per zone.
Zones- Enabled, allows for editing current zone clamp location and pressure pad
location. Also, allows user to add new zones to a plate.
16-148