Stand-Alone Punch machine user manual - Finn-Power International ...

a. Add all small round hits [0.25” (7mm)]- Hits are added one by
one. Left click on a small round hit and then right click to add to
dialog. Repeat until all small round hits appear in cycling dialog.
b. Add 0.375” (9mm) hits- left click on hit and then right click to
add into dialog. Repeat for each hit of this type.
Step 4: Save cycle. Click Save on dialog. Next screen will appear with three
selections (Create, Destroy, or Break), select Create and click OK.
A cycle was created for all round singe punch hits in the part. This means that
the punches will be carried out in that order. The next steps will re-order the
way the punches will be done.
Re-ordering Hits
Step 5: Open manual cycling dialog, left click on a tool that is in the newly
created cycle. (All tools should be highlighted) Right click to add cycle to
dialog.
Step 6: Change the order so that all 0.375” (9mm) tools at the top of list:
a. Within the list highlight all desired tools, either by holding down
CTL key and selecting each one or by selecting one, holding left
mouse button down and dragging cursor over each item.
b. Once all desired tools are selected, click Switch Up. All selected
tools will be moved up one tool. Repeat until tools are at the top
of the list.
Step 7: Change the order of round 0.25” (7mm) tools:
a. Select bottom two tools on list.
b. Click Switch Up six times to change tool order, so that the 0.25”
(7mm) tools are cycled within the 0.375” (9mm) tool.
4-70