Stand-Alone Punch machine user manual - Finn-Power International ...

the desired tool to be used on the start and end points. Extensions can be
modified to change the overlap outside the edge of the vertex of the tool that
is used to nibble.
Delete rectangle tooling within part:
Replace- (Edit menu | Replace) Select each of the rectangle tools in the
‘Find tool ID’ drop down, then click Remove. Both rectangle tools will be
removed separately.
1. Click Setting Nibble Priorities in the Nibble dialog.
2. Modify Extension 1 & Extension 2: -0.006” (-0.15mm)
3. Click on each of the outside contour line segments to add rectangle
tooling. (Also tool the inside cutout)
Part should look similar to picture below.
Nibbling Radius Contours
When adding a round tool nibble path to a radius contour the most important
Nibble Property is the Scallop Maximum. The scallop maximum will
adjust the size of the teeth left when nibbling with a round tool.
1. From the Nibble dialog select a round tool- 0.5” (12mm)
2. Click Setting Nibble Properties
a. Change Scallop Max: 0.03” (0.8mm)
3. Click on Round cutout on right side of the part to add nibble path.
(Go to View menu | Display – select Expand Nibbles, to view single
hits made. Zoom in to get a better view of hole.)
4-64