Stand-Alone Punch machine user manual - Finn-Power International ...

The part should look similar to picture above. Notice the yellow arrows
placed on the external and two internal (square and round cutouts) contours,
this is displaying that sorting is applied to the part for each of the contours.
This particular part has manual sorting applied which means that the last hit
of that contour has the sorting applied to remove the piece. When manual
sorting is applied to a part, M00 is applied to the NC file automatically when
the last hit is punched for that contour. To display what type of sorting is
applied when yellow arrow appears go to Edit menu | select Unloaders.
4.4.7.1.2 EXERCISE 2- Destruct Cutout/Notch
Exercise 2 will demonstrate how Destruct will be applied to internal round
or rectangular contours and external contours within AutotoolSA.cp. Along
with destructing the internal contours, outside expansion will be used to
place square tooling to the outside contour notch of the part.
Step 1: Use/Open AutotoolSA.cp
Step 2: Before opening Autotool two lines will need to be selected.
Select one line segment from the large internal cutout, hold down shift,
then select one line segment from external contour.
Step 3: Open Autotool dialog
Step 4: For this exercise, only one tab will be modified in the Autotool
dialog- Destruct, follow screenshot below. Use same values for all other
tabs and keep microjoints de-activated.
4-50