Stand-Alone Punch machine user manual - Finn-Power International ...
Stand-Alone Punch machine user manual - Finn-Power International ...
Stand-Alone Punch machine user manual - Finn-Power International ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
NOTE- If the tool’s center point has been changed all parts that have used<br />
the tool will need to be re-tooled for only the special tool that has changed.<br />
2.1.2 Setting Die Clearances<br />
NC Express keeps track of die clearances for each tool in the tool library. Each tool<br />
will have dies declared and each material type will have a die clearance range set.<br />
Setting the die clearance range will allow for use of tools which have a die that falls<br />
between the lower and upper limit set for the die range. The following explains<br />
how the dies can be set in NC Express and how to set the die range.<br />
Step 1: Setting Dies for each tool<br />
If no Tool library database exists, on first<br />
open of NC Express you will be asked to<br />
enter a die clearance (shown right). What<br />
will happen when you click OK is that the<br />
die clearance you entered will be added as<br />
default for all tools in the tool library. At this point, choose a die clearance that will<br />
work for all or most tools in your tool library. More than one default die clearance<br />
may be added at this point, click Yes to add another die clearance. Note- Adding a<br />
default die clearance adds to all tools. If you have added the die clearance to all and<br />
some may not have that die you will have to open the tool library and delete the<br />
undesired die per tool.<br />
Remember- The first time you open NC Express after the update will ask for the<br />
die clearances. Die clearances can be added <strong>manual</strong>ly also.<br />
Manually editing<br />
Adding- Above shows how to add a die to a tool <strong>manual</strong>ly. Open a tool in the tool<br />
library, click add die, then type the value for the die. Two similar tools can be setup<br />
2-15