Stand-Alone Punch machine user manual - Finn-Power International ...

9.1 USE SPLIT-SCREEN PART DIALOG __________________________________9-119
9.1.1 REMOVING PARTS FROM LIST __________________________________________ 9-119
9.1.2 SAVING MODIFIED PART LIST __________________________________________ 9-119
9.1.3 CLOSING THE SPLIT-SCREEN ___________________________________________ 9-120
9.2 REPORTS (SETUP SHEET) _________________________________________9-120
9.2.1 NEST REPORT _______________________________________________________ 9-120
9.2.2 JOB SHEET _________________________________________________________ 9-120
9.2.3 REPORT____________________________________________________________ 9-120
9.2.3.1 SELECTING A REPORT TYPE __________________________________________ 9-120
9.2.3.2 SAVING A REPORT__________________________________________________ 9-120
9.2.3.3 PRINTING THE REPORT ______________________________________________ 9-121
9.2.3.4 COPY THE REPORT _________________________________________________ 9-121
10 ORDERS MANAGEMENT SYSTEM (MRP NESTING)___ 10-122
10.1 DATABASE ORDERS DIALOG_____________________________________10-122
10.2 ADDING/MODIFYING PARTS IN ORDERS DATABASE __________________10-123
10.3 EXERCISE- USING ORDERS DATABASE_____________________________10-126
11 APPENDIX A- MODIFY TOOLING ___________________ 11-129
12 APPENDIX B- SPECIAL TOOL INFORMATION _______ 12-135
13 APPENDIX C- DIE CLEARANCE SUGGESTIONS ______ 13-138
14 APPENDIX D- AUTOTOOL SETTINGS________________ 14-140
15 APPENDIX E- INTERACTIVE OPTIMIZER ___________ 15-144
16 APPENDIX F- INTERACTIVE ZONES SETTINGS ______ 16-147
1-7