LaCie 2big Network 2 Hard Disk Manual - Tape Resources
LaCie 2big Network 2 Hard Disk Manual - Tape Resources
LaCie 2big Network 2 Hard Disk Manual - Tape Resources
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>LaCie</strong> <strong>2big</strong> <strong>Network</strong> 2 • DESIGN BY NEIL POULTON<br />
Introduction<br />
User <strong>Manual</strong> page 11<br />
1.4.3. LED Behavior<br />
The front and rear LED indicate drive status and activity. This section describes the behavior of the LED indicators.<br />
TECHNICAL NOTE: Even if you have turned off the front LED using the Dashboard (4.12. Dashboard: Eco Management), events triggering a red<br />
light will always cause the front LED to turn on.<br />
Front LED Color Rear LED Color <strong>2big</strong> <strong>Network</strong> 2 State<br />
Blinking blue<br />
Activity LED for working disk(s)<br />
(until they are fully initialized)<br />
Occurs as the <strong>2big</strong> is booting; will cease once the drives are fully initialized<br />
RAID synchronizing; will cease once operation has concluded<br />
Solid blue Activity LED for working disk(s) Drive working (read/write)<br />
Blinking blue/red<br />
Activity LED for working disk(s)<br />
Solid red in non-functional disk(s)<br />
RAID is degraded; data is intact but no longer protected from further failed<br />
disks<br />
Blinking red<br />
Activity LED for working disk(s)<br />
Activity LED for working disk(s)<br />
Power supply has been cut but power is still being supplied through the<br />
UPS<br />
Temperature alert (first level)<br />
Temperature alert (critic level) – the product will shut off<br />
Solid red<br />
Activity LED for working disk(s)<br />
Solid red in non-functional disk(s)<br />
Power supply has been cut and the UPS has run out of reserve power – the<br />
product will shut off<br />
RAID has failed and data has been lost