ER-A440 Operation-Manual GB - Sharp

Selection of X1/Z1 and X2/Z2 reports
to be printed in the stacked report sequence
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be printed
in sequence with only a single request, up to maximum of 13 reports*. This function continuously prints a
maximum of 13 kinds of reports with a single operation.
Procedure
2620
. ≈
*1
Job no.
Start range
End range
≈ parameter ≈ parameter : ;
*: Maximum 70 steps are programmable. “1 step” means the memory size used for one no-range type job no.
The range type job no. needs “8 steps”.
Job code numbers to be used are as follows.
*1 *2
Job no. Report Available mode Range parameter
00
10
General report
Full department report X1/X2 mode only
13 Full department group report X1/X2 mode only
20 PLU report *3 Start PLU code/end PLU code (1 through 999999)
27 PLU zero sales report X1/X2 mode only
29 PLU price category report X1/X2 mode only *3 Start price amount/end price amount
30 Transaction report
X1/X2 mode only
31 Total in drawer report X1/X2 mode only
32
40
50
60
Commission sales report
Full clerk report
Full cashier report
Hourly sales information Range report is available *3 Start time/end time (0 through 2330)
only in the X1 mode.
70 Daily net report
X1/X2 mode only
*3: Both range setting and full setting are allowed.
To cancel the stacked report sequence
For full reporting (non-range report)
*2
To repeat*
*2
PGM 2
For individual reporting
2620
Note
When Z of stacked report is initiated, X only reports will be skipped.
Example
Key operation
2620 . ≈
10 :
13 :
;
Print
61