ER-A440 Operation-Manual GB - Sharp

2
Automatic modification of register system for introduction of EURO
To make your register correspond to the introduction of EURO, your register system can be automatically
modified when the procedure shown below is executed in the Z2 mode.
Procedure
800 *A (1 or 2)
. ≈ ;
*A=1: Applicable for the period of co-existence of EURO and national currency. (During the transition period)
*A=2: Applicable for the time the national currency is withdrawn from circulation. (At the completion of
transition period.)
Note
• You can perform the each operation only once with the substitution of “A=1” and “A=2”. If you
performed the operation with the substitution of “A=2” first, you cannot perform the operation with
the substitution of “A=1”.
• After the execution of the procedure above, EURO is treated as domestic currency, and National
currency as foreign currency. Program the rate of national currency for EURO to the exchange
1([) key.
The details of the register system modification are as follows:
When “1” is substituted to “A”:
1. Issuing a general Z1 report (Job #100).
2. Issuing a general Z2 report (Job #200).
3. Resetting GT1, GT2 and GT3.
4. Setting “Yes” for a PGM function “Printing exchange 1 total amount and change amount on receipt and
journal” (Job #2616)
5. Changing the domestic currency symbol to EURO symbol.
When “2” is substituted to “A”:
1. Issuing a general Z1 report (Job #100).
2. Issuing a general Z2 report (Job #200).
3. Resetting GT1, GT2 and GT3.
4. Setting “No” for a PGM function “Printing exchange 1 total amount and change amount on receipt and journal”
(Job #2616)
5. Changing the domestic currency symbol to EURO symbol.
Note
When the operation with the substitution of “A=1” has been performed already, only 1, 2, and 4 are
executed.
75