PRE-DRIVE C2X Deliverable D0.3 Final report_20100929.pdf

Final Report PRE-DRIVE C2X 29.9.2010
D1.3: “Refinement and extension of the security architecture”
D1.4: “Consolidated system and security architecture with input from the
COMeSafety system architecture specification (version 2.0)”
D1.5: “Final refinement of D1.4 with input from the COMeSafety system
architecture specification (version 3.0)”
These deliverables were elaborated and consolidated with the European ITS
architecture for cooperative systems from COMeSafety. The results have been the
basis for the work in WP3000.
Moreover, the results have been significant input to standardisation documents in
ETSI.
Figure 12 shows how the cooperative systems and the ITS architecture activities fit
together and how the results will be integrated in the ETSI standardisation process.
PRE-DRIVE C2X as member of the COMeSafety Architecture Task Force
cooperated amongst others with COMeSafety, COOPERS, SAFESPOT, CVIS and
E-FRAME. Within WP1000 PRE-DRIVE C2X contributed to a common European
ITS Communication Architecture.
Figure 12: Overview how the cooperative systems and ITS architecture activities fit together
All results of WP1000 are described in the deliverables mentioned above. In the
following only some major aspects of the system architecture work are highlighted.
First the system domains have been identified and described. Figure 13 represents
the highest level of abstraction of the ITS architecture and thus it is provider
independent. The ITS architecture can be used in different scenarios to adapt to
different economic and regulatory conditions, facilitating a gradual introduction of
ITS. Basically, a deployment scenario is a sub-set of the overall architecture created
by a combination of the different sub-domains.
Deliverable D0.3 Version 1.0 24
Final Report