PRE-DRIVE C2X Deliverable D0.3 Final report_20100929.pdf

Final Report PRE-DRIVE C2X 29.9.2010
In order to deduce a suitable test system, representative test cases were edited.
Based on these, the requirements for the test system were deduced within this work
package. Each requirement was evaluated for instance if it is mandatory or not. An
overview of these requirements is given in deliverable D4.2 “Requirements and
specification of testing architecture and procedures and requirements and
specification of test management centre”, which also includes the basic test system
architecture and specification.
With regard to the field operational test environment (see chapter 2.2.4), we
identified, specified and realized the following sub-systems (see Fehler!
Verweisquelle konnte nicht gefunden werden.):
the test operator client,
the test management centre,
the ITS testing unit and
the test driver communication unit. .
Figure 43: Specified and implemented FOT test system architecture
Test operator client
The test operator client provides the user interface for the test operator. With help of
this sub-system, the operator is able to define test cases or scenarios (scenario
editor tool), to monitor the test (CODAR viewer) and to control the test in real-time
(test control tool). All these tools were implemented, integrated and tested. They are
available and ready to use.
Figure 44 shows the Scenario Editor. This is a web-based tool to define scenarios,
in which a number of routes to be driven are defined. It provides the possibility to
define the complete test run, including the selection of involved vehicles, adjusted
vehicles’ trajectories, location-based test triggers and the selection of log and
monitoring data. The Test Control provides an instrument to control tests in real-
Deliverable D0.3 Version 1.0 55
Final Report