V50 w646.book - ESD - Volvo

09 Maintenance and service
Replacing bulbs 09
Fog lamps
Removing the bulb holder
– Press the bulb holder into place and refit
the cover (A or B).
NOTE
If the error message BULB FAILURE/
CHECK STOP LAMP remains after a faulty
bulb has been replaced then consult an authorised
Volvo workshop.
– Switch off all lights and turn the ignition
key to position 0.
– Remove the panel from around the lamp
housing.
– Remove the two Torx screws securing the
lamp housing and take out the lamp housing.
– Unplug the connector from the bulb.
– Turn the bulb anticlockwise and pull it out.
– Fit the new bulb and turn it clockwise.
– Plug in the connector to the bulb.
– Secure the lamp housing with the screws
and press the panel back into place.
– All bulbs in the rear lamp cluster can be
changed from inside the cargo area.
– Switch off all lights and turn the ignition
key to position 0.
– Remove the cover (A or B) in the left/righthand
panel to access the bulbs.
– These bulbs are located in separate bulb
holders.
– Unplug the connector from the bulb holder.
– Squeeze together the catches and remove
the bulb holder.
– Replace the bulb.
– Plug in the connector.
195