V50 w646.book - ESD - Volvo

02 Instruments and controls
Left-hand stalk switch
Stalk switch positions
1. Short flash sequence, direction indicators
2. Continuous flash sequence, direction
indicators
3. Main beam flash
4. Switching, main and dipped beam, and
home safe lighting
Direction indicators
Continuous flash sequence
– Move the stalk switch up or down to end
position (2).
The stalk switch remains in its end position
and is moved back manually, or automatically
by steering wheel movement.
Short flash sequence
– Move the stalk switch up or down to
position (1) and release.
The direction indicators flash three times and
the stalk switch returns to its home position.
Switching, main and dipped beam
The ignition key must be in position II for
main beam to be switched on.
– Turn the headlamp control clockwise to
the end position, see page 49.
– Move the stalk switch towards the steering
wheel to the end position (4) and release.
Main beam flash
– Move the stalk switch gently towards the
steering wheel to position (3).
Main beam comes on until the stalk switch is
released.
Home safe lighting
Some exterior lights can be kept lit and serve
as home safe lighting after the car is locked.
The standard delay is 30 seconds 1 , but can
be changed to 60 or 90 seconds; see
page 69.
– Remove the key from the ignition switch.
1 Factory settings.
– Move the stalk switch towards the steering
wheel to the end position (4) and release.
– Get out of the car and lock the door.
02
51