1 The AVM ISDN-Controller B1 PCI v4.0 - VoipAndGo

Installing the Driver Software
5.1 Installing the Driver Software
Once the ISDN-Controller B1 PCI v4.0 has been installed in
your computer, it will be recognized automatically as a Plug
& Play device. Use the Found New Hardware Wizard to configure
the ISDN-Controller for operation. To do so, proceed as
follows:
The following dialogs are part of the Windows 2000 operating
system. Consult the Windows 2000 manual wherever
necessary.
1. Start the computer.
The Found New Hardware Wizard recognizes a new Plug
& Play device to be installed.
2. First specify the D-channel protocol to be used. Select
the DSS1 (Euro ISDN) protocol here, even if 1ESS or NI1
is used on your line. Confirm your selection by clicking
“Next.”
3. Enter the desired multiple subscriber numbers in the
“Phone Number and SPID Information” window.
The settings performed in this dialog are relevant only
for the NDIS WAN CAPI Driver (Internet, RAS over Dial-
Up Networking). They have no effect on other ISDN
software.
The MSNs entered here are valid for both incoming and
outgoing calls. The first MSN entry is valid for the first B
channel; the second for the second B channel. A maximum
of two B channels is supported by the NDIS WAN
CAPI Driver. When a B channel is busy, the first MSN
(default MSN) will be signaled as the outgoing MSN.
Tip: simply enter the same MSN for both B channels to
monitor all costs accrued on this number.
4. Click “Next”.
Please be patient for a few seconds while the ISDN-Controller
B1 PCI v4.0 installation is being concluded.
Once the driver installation is concluded, the second step is
to update the driver software from the installation CD.
22 ISDN-Controller B1 PCI v4.0 – 5 Installation in Windows 2000