1 The AVM ISDN-Controller B1 PCI v4.0 - VoipAndGo

Changing the Settings
By default the ISDN-Controller B1 PCI v4.0 is loaded automatically
every time Windows NT is started. Because the
controller is loaded before the items in the “Startup” program
group, it is no problem to include communications programs
based on CAPI in the “Startup” group.
6.2 Changing the Settings
After installation has been concluded, you have the option of
changing the following settings of the ISDN-Controller B1 PCI
v4.0:
� D-channel protocol: DSS1 (Euro ISDN), NI1, 5ESS, 1TR6
� enable automatic data compression (CAPI SoftCompression
X75/V42bis)
Open the “B1 Setup” program from the “AVM” program
group and follow the instructions there.
Information on CAPI SoftCompression can be found in the
section “CAPI SoftCompression X75/V42bis” on page 69.
6.3 Installing Additional Controllers
Up to four active AVM ISDN-Controllers can be installed in
your computer. Active AVM ISDN-Controllers for the ISA, PCI
and PCMCIA buses can also be combined in the same system.
To install an additional ISDN-Controller for the PCI bus, simply
insert it in a suitable slot as described in “Installing the
ISDN-Controller B1 PCI v4.0” on page 12 and start Windows.
Make your settings in the dialogs as described in the section
“Installing the Driver Software” on page 27. That’s all!
If you want to add another active ISDN-Controller, carry out
the controller installation procedure as described in the appropriate
manual.
The driver software for all installed ISDN-Controllers is loaded
automatically when Windows starts.
ISDN-Controller B1 PCI v4.0 – 6 Installation in Windows NT 29