Technical Reference Manual - InduSoft

Alarms, Events, and Trends
On the X Axis field we need to indicate which column in our text file represents the X Axis. In our example
we are using column zero, so enter 0 for this field, then click Data Source Settings…. The following window will
display:
Selecting the text file
If you have copied the text file to the project folder, you only have to specify the file name, otherwise, enter
with the complete path where the file is located (use the browse button as needed). Click OK on this window
and OK again to finish the data source configuration and close the Data Source configuration Window.
Now we need to define our Y1 and our Y2. They will be represented by points on our Trend Control. Doubleclick
on the Trend Control again to access the Object Properties window and then click on Points…. Your next
step is to define the points according to the following figure:
After following these steps, run your project and you should see something similar to the figure below:
InduSoft Web Studio Page 289