Technical Reference Manual - InduSoft

About thin clients and mobile access
3. Copy the files to non-volatile memory on the Windows Embedded device.
4. Register the ISSymbol control on the Windows Embedded device by executing the following command from
the Prompt window:
regsvrce.exe "\ISSymbolPath\ISSymbolCE.ocx"
Example:
regsvrce.exe "\Storage Card\ISSymbolCE.ocx"
5. Save the registry settings to keep ISSymbolCE.ocx registered when you reboot the Windows Embedded
device.
Tip: Check the device manufacturer's documentation for how to save the registry settings.
6. Start the Secure Viewer by running Viewer.exe.
Changing the Secure Viewer Configuration
After initial installation, the configuration of the Secure Viewer is saved in the viewer.ini file, which should be
in the same directory as Viewer.exe. (This should be in the \Bin sub-folder where the Secure Viewer program
is installed). There are two ways to change the configuration of the Secure Viewer after it has been installed.
First, you can run the Viewer configuration utility (ViewerCfg.exe) that was also installed.
Note: On WIndows Vista and Windows 7, the Secure Viewer configuration utility must have
Administrator privileges to run properly. It should be installed with those privileges by default, but
if you still have problems, then check the file properties for ViewerCfg.exe and make sure Run as
Administrator is selected.
The configuration utility provides the following options:
• Save button: Immediately save the current settings to a viewer.ini in the same directory as the
ViewerCfg.exe utility.
• Import button: Load a viewer.ini file from another directory.
• Export button: Save the viewer.ini file to another directory.
• Data Server IP field: Enter the IP address (or host name) of your data server station.
The data server station is the computer or device where the TCP/IP Server module is running.
• TCP Port field: Enter the port number of the Data Server, if it is different than the default port of 1234.
• URL field: Enter the URL or filepath of the project file (*.app) on the Web Server.
• Enable Splash Window option: Check (enable) this option to see a splash window when you start the
Secure Viewer.
• Enable Progress Bar option: Check (enable) this option to see a progress bar while the Secure Viewer
loads the project file.
InduSoft Web Studio Page 455