Wavelink Avalanche Site Edition Java Console User Guide

Chapter 7: Managing Network Profiles 66
For example:
0.0.0.255
7 Click Add to add the IP addresses to the IP address pool.
The available addresses and the mask will appear in the table to the right.
This list will display all entered addresses, including those already
assigned.
8 Click OK to return to the Network Profiles tab.
9 Save your changes.
Adding Authorized Users
You can add authorized users for all network profiles or enable a user for a
specific network profile. For information on adding an authorized user, see
Chapter 5: Managing User Accounts on page 43.
Configuring Selection Criteria
Selection criteria allow you to specify which devices the network profile
manages. Mobile device criteria define which mobile devices are managed by
the profile. Dynamic selection criteria are defined by Avalanche and apply to
a device’s encryption and authentication support.
For detailed information about creating selection criteria, refer to Chapter 14:
Using Selection Criteria on page 163.
Configuring Scheduled Settings
From a network profile, you can configure WLAN IP settings, WLAN SSID,
encryption and authentication settings, and WWAN settings. These
configurations are based on epochs, so they are considered scheduled
settings.
Epochs allow you to change the settings for a network profile and apply those
changes at a specific time. When you configure WLAN IP, WLAN, and
WWAN settings, you select which epoch those settings are effective for.
NOTE If you have an older Enabler, it will receive the new network settings
the first time it connects with the server after the epoch start time.