Optimod-AM 9400 V1.2 Operating Manual - Orban

2-48
INSTALLATION ORBAN MODEL 9400
See your network administrator to get the data required in the following
procedure.
Note that if you wish to do this from the 9400 PC Remote software, you
must first be able to connect to the 9400. Therefore, you will usually perform
this procedure from the 9400’s front panel to prepare it for connection.
A) Navigate to SETUP > NETWORK & REMOTE > NEXT.
B) Press the SET IP ADDRESS soft button.
The IP Address Screen appears.
a) Use the NEXT and PREV keys to move the cursor in turn to each digit in the
IP address. Use the knob to set the digit to the desired value. Repeat until
you have selected all the numbers in the IP address assigned by your
network administrator
b) Press the SAVE soft button to confirm your setting.
C) Set the Subnet Mask assigned by your network administrator if necessary:
a) Press the SET SUBNET MASK soft button.
b) Use the NEXT and PREV keys to move the cursor in turn to each digit in the
subnet mask. Use the knob to set the digit to the desired value. Repeat
until you have selected all the numbers in the subnet mask assigned by
your network administrator
c) Press the SAVE soft button to confirm your setting.
D) Set the Gateway Address assigned by your network administrator if necessary:
a) Press the GATEWAY ADDRESS soft button.
b) Use the NEXT and PREV keys to move the cursor in turn to each digit in the
gateway address. Use the knob to set the digit to the desired value. Repeat
until you have selected all the numbers in the gateway address assigned by
your network administrator
c) Press the SAVE soft button to confirm your setting.
E) Set the IP Port assigned by your network administrator if necessary:
a) Press the IP PORT soft button.
b) Use the NEXT and PREV keys to move the cursor in turn to each digit in the
IP port. Use the knob to set the digit to the desired value. Repeat until you
have selected all the numbers in the IP port assigned by your network
administrator
c) Press the SAVE soft button to confirm your setting.
F) Connect your Ethernet network to the RJ45 jack on the rear panel of your
9400.
If you are connecting to a hub or router, use a standard Ethernet cable.