view user manual (pdf) - dyna-flo control valves

Operation
No.
Abbreviation
Meaning
Displayable
values
Unit
Rest
poss.
31 VENT1 Number of cycles pre--controlvalve 1 0to4.29E9 --
32 VENT2 Number of cycles pre--controlvalve 2 0to4.29E9 --
33 STORE Store current values as ”last maintenance”
-- --
(press increment key for 5 s)
34 PRUP Prediction up 1to40 --
35 PRDN Prediction down 1to40 --
36 WT00 Number of operating hours in distance class WT00 0to4.29E9 Hours x
37 WT05 Number of operating hours in distance class WT05 0to4.29E9 Hours x
38 WT10 Number of operating hours in distance class WT10 0to4.29E9 Hours x
39 WT30 Number of operating hours in distance class WT30 0to4.29E9 Hours x
40 WT50 Number of operating hours in distance class WT50 0to4.29E9 Hours x
41 WT70 Number of operating hours in distance class WT70 0to4.29E9 Hours x
42 WT90 Number of operating hours in distance class WT90 0to4.29E9 Hours x
43 WT95 Number of operating hours in distance class WT95 0to4.29E9 Hours x
44 mA Current setpoint 0.0 to 20.0 mA
Table 4-1
Overview diagnostic values
4.5.2 Meaning of the diagnostic values
1 STRKS
Number of strokes
The actuator movements during operation are totaled and can be read
here as number of strokes. Unit: 100% stokes The value is written every
15 minutes in a non--volatile memory. It can be reset to zero with
the increment key .
2 CHDIR
Number of direction changes
Every change in direction leaving the dead zone is noted in the
controller and added to the number of changes of direction.
The value is written every 15 minutes in a non--volatile memory. It can
be reset to zero with the increment key .
3 CNT
Fault counter
Every fault is noted in the controller and added to the number of fault
messages. The counter can be reset to zero with the increment key .
SIPART PS2 Manual
A5E00074631-03
99