SERVICE MANUAL - Alarko Carrier
SERVICE MANUAL - Alarko Carrier
SERVICE MANUAL - Alarko Carrier
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
No.<br />
Part name<br />
Procedures<br />
Remarks<br />
6<br />
Bearing<br />
1) Follow to the procedure in the items 1 .<br />
2) Remove the two fixing screws used to secure<br />
the left edge panel of the heat exchanger, and<br />
remove the two screws used to secure the<br />
bearing base.<br />
Screw<br />
Bearing<br />
base<br />
Screw<br />
3) Raise the left side of the heat exchanger<br />
slightly, and remove the bearing base.<br />
<br />
• If the bearing is out from the housing, push it<br />
into the specified position and then incorporate<br />
it in the main body.<br />
• After assembling the bearing base, check that it<br />
is fitted into the stepped part of the drain pipe.<br />
Raise the left side<br />
Remove in this direction<br />
Bearing base<br />
Bearing<br />
Drain pipe<br />
Drain pipe<br />
Bearing base<br />
– 112 –