SERVICE MANUAL - Alarko Carrier
SERVICE MANUAL - Alarko Carrier
SERVICE MANUAL - Alarko Carrier
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
(4) Indoor fan motor automatically starts to rotate by turning on power supply<br />
<br />
The IC is built in the indoor fan motor. Therefore the P.C. board is also mounted to inside of the motor.<br />
If the P.C. board is soldered imperfectly or the IC is defective, the fan motor may automatically rotate by turning<br />
on power supply.<br />
<br />
1. Remove the front panel. (Remove 2 screws.)<br />
2. Remove the cover of the fan motor lead wires.<br />
3. Check DC voltage with CN10 connector while the fan motor is rotating.<br />
NOTE :<br />
• Do not disconnect the connector while the fan motor is rotating.<br />
• Use a thin test rod.<br />
Indoor fan starts rotating when power supply is turned on.<br />
P.C. board<br />
(Check output DC voltage of fan motor on P.C. board.)<br />
Measure voltage between 3 (GND : BLACK)<br />
and 5 (V line : YELLOW) of motor connector (CN10)<br />
while indoor fan motor is rotating.<br />
Yellow<br />
Black<br />
CN10<br />
6 (Blue)<br />
5 (Yellow)<br />
4 (White)<br />
3 (Black)<br />
2 –<br />
1 (Red)<br />
DC 1.0V or more<br />
Under DC 1.0V<br />
DC<br />
P.C. board is defective.<br />
Motor is defective.<br />
Replace P.C. board.<br />
Replace motor.<br />
– 94 –