SERVICE MANUAL - Alarko Carrier

More documents

Recommendations

Info

10. INSTALLATION PROCEDURE 10-1. Safety Cautions Hook 47 mm or more 1 Installation plate Hook For the rear left and left piping Wall 140 mm or more Hook 74 mm or more Insert the cushion between the indoor unit and wall, and tilt the indoor unit for better installation work. 7 Mounting screw Do not allow the drain hose to become slack. 5 Zeolite-plus filter 6 Plasma pure filter Z Shield pipe (for extension drain hose) Cut the piping hole slightly sloped Make sure the drain hose is sloped downward. Air filters Y The auxiliary piping can be connected at the left, rear left, rear right, right, bottom right or bottom left as shown below. 2 Wireless remote controller 100 mm or more from wall 4 Remote controller holder (Mounting holes on both left and right sides) (C) 80 mm or more only when unobstructed to the front and both sides In principle, leave open 50 mm or more from wall (D) Right Rear right Bottom left Left Bottom right Rear left 8 Remote controller holder mounting screw 200 mm or more (B) When installing the outdoor unit, leave open in at least two of directions (A), (B), (C) and (D) shown in the right figure. Ensure sufficient space to allow drainage (A) 250 mm or more from wall Power cord Extension drain hose (Option: RB-821SW) As shown in the figure, position power cord and connecting cable downward, and lead out along piping connection port. Insulate the refrigerant pipes separately, not together. 6 mm thick heat resisting polyethylene foam Before installing the wireless remote controller • With the remote controller cover removed, correctly load the supplied batteries while observing their polarity. Cover 3 Batteries 2 Wireless remote controller – 72 –
10-2. Optional Parts, Accessories and Tools 10-2-1. Optional Installation Parts Part Code Y Z Parts name Refrigerant piping Indoor unit name Liquid side (Outer diameter) Gas side (Outer diameter) RAS-B10GKVP-E, B13GKVP-E 6.35 mm 9.52 mm RAS-B16GKVP-E 6.35 mm 12.7 mm Shield pipe (for extension drain hose) (polyethylene foam, 6 mm thick) Q’ty 1 ea. 1 10-2-2. Accessory and Installation Parts Part No. Part name (Q’ty) Part No. Part name (Q’ty) Part No. Part name (Q’ty) „ ‡ Installation plate × 1 Remote control holder × 1 Mounting screw Ø4 × 25L × 6 ‚ Wireless remote control × 1 … Zeolite-plus filter × 1 ˆ Remote control holder mounting screw Ø3.1 × 16L × 2 ƒ † Name Owner’s manual (Indoor unit) Battery × 2 Plasma pure filter × 1 Installation manual (Indoor unit) Installation manual (Outdoor unit) This model is not equipped with an extension drain hose. Specifications (Outdoor unit) – 73 –
Page 1 and 2:
FILE NO. A05-011-1 Revised on May/2
Page 3 and 4:
1. SAFETY PRECAUTIONS Revised For g
Page 5 and 6:
2. SPECIFICATIONS The indoor and ou
Page 7 and 8:
RAS-M10GKCVP-E, RAS-M13GKCVP-E, RAS
Page 9 and 10:
Outdoor Unit : RAS-4M27GAV-E Power
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Outdoor Unit : RAS-4M27GACV-E Powe
Page 17 and 18:
Page 19 and 20:
Page 21 and 22: Outdoor Unit : RAS-3M26GAV-E Power
Page 23 and 24: 2-2-1. Operation Characteristic Cur
Page 25 and 26: Table 3-2-1 Thicknesses of annealed
Page 27 and 28: 43˚ to 45˚ Table 3-2-6 Flare and
Page 29 and 30: 3-4. Recharging of Refrigerant When
Page 31 and 32: 2. Characteristics required for flu
Page 33 and 34: 4-2. Outdoor Unit RAS-4M27GAV-E, RA
Page 35 and 36: 5-2. Outdoor Unit RAS-4M27GAV-E, RA
Page 37 and 38: 7. REFRIGERANT CYCLE DIAGRAM RAS-B1
Page 39 and 40: RAS-B10GKVP-E, RAS-B13GKVP-E, RAS-B
Page 41 and 42: Outdoor Unit : RAS-4M27GAV-E Tempe
Page 43 and 44: Outdoor Unit : RAS-3M26GAV-E Tempe
Page 45 and 46: 8. CONTROL BLOCK DIAGRAM 8-1. Indoo
Page 47 and 48: 8-2. Outdoor Unit (Inverter Assembl
Page 49 and 50: 9-2. Operation Description 9-2. 1.
Page 51 and 52: Item Operation flow and applicable
Page 53 and 54: Item 2. Indoor fan motor control CO
Page 57 and 58: Item 6. Release protective control
Page 63 and 64: Item 14. Pulse motor valve (P.M.V.)
Page 65 and 66: Item 16. Clean operation release Op
Page 67 and 68: 9-3. Auto Restart Function This ind
Page 69 and 70: 9-5. Remote Controller and Its Fuct
Page 71: 9-6. Hi-POWER Mode ([Hi-POWER] butt
Page 75 and 76: 10-3. Indoor Unit 10-3-1. Installat
Page 77 and 78: CAUTION • Be sure to refer to the
Page 79 and 80: CAUTION • Bind the auxiliary pipe
Page 81 and 82: 10-4-5. Refrigerant Piping Connecti
Page 83 and 84: 10-4-7. Evacuating After the piping
Page 85 and 86: 10-4-10. Miswiring (Mispiping) Chec
Page 87 and 88: 11. HOW TO DIAGNOSE THE TROUBLE The
Page 89 and 90: 11-3. Self-Diagnosis by Remote Cont
Page 91 and 92: Block distinction Check code Block
Page 93 and 94: (3) Only the indoor motor fan does
Page 95 and 96: (5) Troubleshooting for remote cont
Page 97 and 98: 11-5. Trouble Diagnosis by Outdoor
Page 99 and 100: 11-6-2. How to Check Whether the Mi
Page 101 and 102: Diagnosis/Process flowchart Item Co
Page 103 and 104: 11-8-2. P.C. Board Layout GND +12V
Page 105 and 106: 11-8-5. Checking Method for Each Pa
Page 107 and 108: 12. HOW TO REPLACE THE MAIN PARTS W
Page 109 and 110: No. Part name Procedures Remarks 2
Page 115 and 116: 12-2. Microcomputer No. Part name P
Page 117 and 118: No. Part name Procedure Remarks 3 C
Page 119 and 120: No. Part name Procedure Remarks 7 P
Page 121 and 122: - 121 -
Page 123 and 124:
13. EXPLODED VIEWS AND PARTS LIST 1
Page 125 and 126:
13-2. Outdoor Unit 4 6 41, 42 35 23
Page 127 and 128:
13-3. P.C. Board Layout RAS-4M27GAV
Page 129 and 130:
RAS-3M26GAV-E 707 710 715 700 705 T
show all

SERVICE MANUAL - Alarko Carrier

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?