Modifications for the ICOM - RogerK

.------------------------------------.l .----------. ll : : ll : : ll : PA CHIP : ll : : ll : : ll '----------' ll .----. Attach V.O.M. .----. ll : : meter lead --> O : : ll : () : : () : ll : : : : ll : : : : ll '----' '----' ll VHF VCO UHF VCO l'------------------------------------'BottomThis modification is read 987 times.top of page19-07-1998(IC-32) IC-32E auf 9k6Hallo, habe mein IC 32E erfolgreich umgebaut auf 9600BD.NF Ausgang vom IC 32E zum TNC an MAIN UNIT an IC707 TK1042M Pin 11.NF Eingang vom TNC zum IC 32E andie Leitung R779 nach R781 Signale UMOD VMOD.PTT an Stecker J710 Signal PTT.Fragen ueber Box DB0IZ oder Digi DB0END in 1200BD oder 0202/521349.Sowie ueber DB0IZ-9 in 9600BD73 55 Joerg aus Wuppertal DD8JM.PS: UMOD VMOD sind auch auf MAIN UNIT.This modification is read 786 times.top of page19-07-1998(IC-32) IC-32AT Elimination of possible faint pulse noiseModel:Division:Note:IC-32ATAmateurThis service bulletin is meant for technical personnelwith experience working on solid state communicationsequipment. Damage caused by improperlyinstalling this modification may causeICOM to charge for subsequent repairs to theproduct. ICOM does not warrant this modification.Bulletin #: 13889-004Date: May 1, 1989Subject:Information:Elimination of possible faint pulse noise fromspeaker when radio is in power save modeThe power save mode employs a circuit whichcreates a high level square wave signal used inthe power save function. This modification altersthe square wave characteristic to eliminate thenoise.