12.07.2015 Views

Modifications for the ICOM - RogerK

Modifications for the ICOM - RogerK

Modifications for the ICOM - RogerK

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

19-07-1998(IC-28) The long, noisy squelch-tail of <strong>the</strong> Icom IC-28The long, noisy squelch-tail of <strong>the</strong> Icom IC-28 (A or H model) 2-meter transceiver can be shortened by replacing C110 (4.7 uf)with a smaller value (0.1 to 0.47 uf). (I can't remember <strong>the</strong> source of this in<strong>for</strong>mation.)I put a 0.33 uf in my IC-28H; it's a very worthwhile modification.The capacitor is on <strong>the</strong> bottom board (<strong>the</strong> one with <strong>the</strong> lithium battery), just sou<strong>the</strong>ast of IC4 as you face <strong>the</strong> front of <strong>the</strong> upsidedownradio. The only difficult part is finding <strong>the</strong> right p-c pads to desolder on <strong>the</strong> back of <strong>the</strong> board.To remove <strong>the</strong> board: Remove bottom plate, unplug speaker. Unplug coaxial antenna connector (gray wire). O<strong>the</strong>r connectorsmay remain in place. Remove 5 mounting screws, one in each corner and one near center. Tilt <strong>the</strong> board out of <strong>the</strong> radio. Thebutton in <strong>the</strong> upper left corner is CPU reset; you may have to reprogram <strong>the</strong> memories if it is pressed. Remember that, although<strong>the</strong> radio is off, parts of <strong>the</strong> circuit are live so be sure not to short any part of <strong>the</strong> board during <strong>the</strong> modification.This modification is read 1031 times.top of page05-06-1999(IC-2800) Icom IC-2800h Extended RX ModBe<strong>for</strong>e beginning, I naturally accept NO liability if someone screws up this mod! It is direct from Icom America, and worked well<strong>for</strong> me!After mod Frequency Range:118.0 to 135.995(AM/FM)/ 136.00 to 174.00 MHz320.0 to 399.995(AM/FM)/ 400.00 to 530.00 MHzSteps:1. Remove cover (one bolt on cover).2. Look at <strong>the</strong> main board. Locate <strong>the</strong> main processor, under a RF shield.Just to <strong>the</strong> right of it, among all of <strong>the</strong> diodes, you should see a vertical jumper marked W13.3. Cut <strong>the</strong> jumper (do it on top to allow <strong>for</strong> reconstruction later if you want).4. Reassemble to radio, and try it out!Please email any additional mods <strong>for</strong> this rig to: tim@k9tim.com.MODIFICATION.NET . Enjoy!!!!Additional info.In some European models RX is not extended even W13 is removed. To Extend VHF and UHF rx do <strong>the</strong> following trick:Press and hold 4th buttons from top (both, left and right side of <strong>the</strong> display) while turning <strong>the</strong> radio on.This modification is read 2749 times.top of page

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!