Modifications for the ICOM - RogerK

--> hold V/M; fast: FUNC + hold V/M for 2 secChange Memory BANK: FUNC + DIAL; DIAL only (or 2 digits) change channelMemory:push EDIT many times; push ENT on end of each character. Hold EDIT to SAVE.Search Name on memory:FUNC + EASY --> DIAL/keypad --> SCAN --> ENT (to select) or SCAN again, for next matchScan edge set:FUNC + 4 (VFO mode)Scan edge set for AUTO MEMORY:FUNC + 5 (VFO mode)RX mode set for MODE SELECT scan:FUNC + 7 (MEMORY mode)Priority watch:select QRG --> FUNC + hold 9 (to set); FUNC + 9 turns on/off watch every 5 secs (if signal is present, pauses 5 secs)BAND SCOPE:SCAN:EASY:10 channels (max [default] 20 KHz apart each), centred. only with FM in VFO mode! CLR for escape.DIAL turn scan direction (if running) or starts again while pausingVSC: scans (pauses) only modulated signalDELAY: FUNC + CLR --> EDIT many times until SCAN DELAY appearsSKIP: QRGs in BANK R are skipped ("SKIP" is displayed)STOP scanning: SCAN or CLRPROGRAM: FUNC + 4 --> DIAL; S = Start E = End --> SCAN; EDIT to changeAUTO WRITE MEMORY:FUNC + 5 (as above); store in BANK QFUNC + V/M skips unwanted signals Automatically overwrite old Q BANKBANK scan: FUNC + 8 (as above)MODE scan: FUNC + 7 --> MODE; (as above)SKIP: FUNC + CLR --> push EDIT untill SKIP options (CLR to finish) PROGRAM SKIP ON --> VFO --> SCAN --> to BANK R(FUNK + V/M skips)SIGNAVI:only FM! Speeds up scanning.Jumps up to 100 kHz to the NEXT busy QRG (= max. 5 steps)VFO --> FUNC + 6 --> FUNC + 4 or 5... (as above)EASY --> number of program --> SCAN (as above); EDIT to changeSET mode:AFC:LOCK:ATT:FUNC + CLR --> EDIT many times as neededonly FM! = Automatic Frequency Control when out of center (retunes) FUNC + "."FUNC + EDIT