12.07.2015 Views

Modifications for the ICOM - RogerK

Modifications for the ICOM - RogerK

Modifications for the ICOM - RogerK

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

5. Reset <strong>the</strong> CPU and you're done!6. If you mess up your radio I take NO RESPONSIBILITY. You do this at your own risk.If anything you'll break <strong>the</strong> back light as most people do... But to help not do this <strong>the</strong> transistor d14 DOES NOT LOOK LIKEd13!!!This modification is read 757 times.top of page06-03-2002(IC-2GXAT) Software mod, to open IC-2GXATAuthor: - Happy_Hamer2001@yahoo.com.MODIFICATION.NETThis is a software mod to open up <strong>the</strong> receiver <strong>for</strong> <strong>the</strong> IC-2GXAT.(YOU DO NOT NEED TO EVEN TAKE THE RADIO APART!)1. Turn off <strong>the</strong> radio.2. Press and hold <strong>the</strong>, F KEY, Scan and Dup keys.3. While holding all 3 keys turn on <strong>the</strong> radio, continue to hold <strong>the</strong> keys <strong>for</strong> about 3 seconds WAITING until <strong>the</strong> display returnsto normal be<strong>for</strong>e releasing <strong>the</strong> keys.I did this to my HT and it receives from 50Mhz – 204Mhz.This modification is read 188 times.top of page19-07-1998(IC-2IA) IC-2Ia mic modsHello folks...I bought an ic-2Ia last week <strong>for</strong> use by my xyl kb8czl. I chose this particular ht <strong>for</strong> its simplicity of operation (afterinitial setup).However, it didn't take long be<strong>for</strong>e we began receiving poor xmit audio reports. It was described as "muffled and constricted -like talking thru a garden hose".As it turns out <strong>the</strong> design engineers at icom left no provision to get <strong>the</strong> melodious tones of your voice to <strong>the</strong> microphone exceptto go thru <strong>the</strong> plastic case.After i noticed this problem, i returned <strong>the</strong> radio to my dealer and tried several o<strong>the</strong>rs. They all sounded <strong>the</strong> same. Then <strong>the</strong>salesman called icom service-<strong>the</strong>y admitted <strong>the</strong>y knew of <strong>the</strong> problem and recommended a hole be drilled in front of <strong>the</strong> mic.Heres how to do it - proceed carefully-1. Shut off radio2. Remove battery pack3. Remove 4 phillips head screws from rear of case4. Carefully pull off front of case5. Gently remove mic element from rubber holder6. Unscrew 4 phillips head screws retaining speaker7. Support case on soft surface8. Drill hole thru center of mic rubber from inside - i used 5/64 inch (2mm) drill9. Reassemble in reverse order10. Marvel at fb audio11. Thats it, folks...Hope you like your new ht as much as we do...73, ART-K8CIT..This modification is read 584 times.top of page

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!