Modifications for the ICOM - RogerK

Push the [left arrow] button to enter TX freq.I have not been able to get ctcss entered this way yet, I'll keep trying.This will only work if Dealer set mode is enabled in the common screen in software.I think enable is by defalt anyhow.Jon.This modification is read 1362 times.top of page30-01-2002(IC-M100) Icom IC-M56, M58, M59, M100 - M125 Additional frq. rangeAuthor: Honico - honico@hotmail.com.MODIFICATION.NET❍❍❍❍Power off radio.Unplug.Inside, under the cover, all have a switch labeled PRV.Centrally located in the small radios; and on circuitry -inside the face, bottom-end - Toggle it to enable *to be released*channels.Coding matches other ICOMs, including handhelds --but not other brands--. See ICOM IC-M11 for freq. chart.This modification is read 190 times.top of page28-01-2002(IC-M11) Icom IC-M11 Additional frequencies and rangeAuthor: honico - honico@hotmail.com.MODIFICATION.NETIC-M11 normally operates in 16K0G3E mode, TX: 156-157.5 and RX 156-163 MHz -but the Normally available channel selectionswon't allow access to all frequencies -Or- channels; some are "locked out". The MEMO (memory channels) have the optionalchannels available:Instructons for unlocking your M-11:*actual key/s you'll press*1. Power on2. Push *MEMO* for MEMO mode3. Push-and-hold BOTH *FUNCTION* + *MEMO* til Right Side (location) flashes.4. *UP-DN* to select a slot numberSelect new channel:5. Press *DIAL* to shift to left side of display to begin selection of Channel number [Left side flashes]6. Press-and-hold *FUNCTION* and click *H/L* ['PRV' is diplayed on screen, centered between sections]7. *UP-DN* to select 00 ~ 116, F1~ P1~ L1~ E1~ C1~ ...whatever...8. press *MEMO* to save and exitNow, your newly selected channels are available (but only) via the MEMOry; -not- DIAL mode. :-(Frequency Alpha Numerics/ Numbers match other Icoms (M58, 59 M100~125 -but NOT other brands.