12.07.2015 Views

Modifications for the ICOM - RogerK

Modifications for the ICOM - RogerK

Modifications for the ICOM - RogerK

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

A friend did this and his IC-2GAT can now transmit 138 to 178 MHz (no RF power output measurements were made). He did noretuning, and did not have to reset <strong>the</strong> CPU. He used a tiny axial-lead glass diode, replaced its leads with wire-wrap wire, andencased it in shrink-tube. The operation requires a super-tiny soldering iron. Observe CMOS soldering precautions: Unplug <strong>the</strong>iron and ground <strong>the</strong> tip be<strong>for</strong>e touching <strong>the</strong> circuit.Remember: Except <strong>for</strong> MARS and CAP, it is illegal to transmit outside <strong>the</strong> ham bands with non-type-approved equipment.This modification is read 1076 times.top of page19-07-1998(IC-2) IC-2AT, If transmit RF indicator notwork properlyModel:Division:Note:IC Micro 2ATAmateurThis service bulletin is meant <strong>for</strong> technical personnelwith experience working on solid state communicationsequipment. Damage caused by improperlyinstalling this modification may cause<strong>ICOM</strong> to charge <strong>for</strong> subsequent repairs to <strong>the</strong>product. <strong>ICOM</strong> does not warrant this modification.Bulletin #: 8988-002Date: March 29, 1988Subject:If transmit RF indicator is not reading properlyProcedure1. Disassemble <strong>the</strong> radio to gain access to <strong>the</strong> RF Board.2. Replace <strong>the</strong> following parts on <strong>the</strong> RF Board:Reference Original New <strong>ICOM</strong>Designator Value Value P/NQ309 2SA 1162 1SS 196 912-00965D309 1SS 211 2.2Meg 1/8WR345Remove this partC349Remove this part3. Reassemble <strong>the</strong> radio.This modification is read 990 times.top of page19-07-1998(IC-2) Icom IC-2GXAT open RX>David, For <strong>the</strong> IC-2GXAT receiver opening do <strong>the</strong> following steps as listed.>>1. Turn off <strong>the</strong> radio>>2. Press and hold <strong>the</strong> " Function, Scan and Dupe keys ">>3. While holding those keys turn on <strong>the</strong> radio.>>4. WAIT until <strong>the</strong> display returns to normal <strong>the</strong>n continue to hold <strong>the</strong>> keys <strong>for</strong> about 2 seconds> after <strong>the</strong> display has returned to normal be<strong>for</strong>e releasing <strong>the</strong> keys>>5. The receiver is now opened up and will cover 138 to 179 Mhz or so.> It WILL NOT do aircraft AM receive nor tune into that frequnecy range.That's an interesting note. I recently did this to my rig (Purchased last may, low serial number) and it receives from about

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!