Modifications for the ICOM - RogerK

●●●350-470 MHz RX/TX800-950 MHz RX1240-1300 MHz RX/TXIC-Delta1A Logic Unit:/---------|| \___________________________| D D D D D | |=ka=|/_|1N916 or 1N914 can be used too.Reset The Radio When FinishedCool radio, too bad its so big and doesn't tx on 800mhz...This modification is read 575 times.top of page14-05-2000(IC-DELTA1) IC-Delta 1E repeater modeAuthor: Walter, DH0KARYou can change the delta 1 E to -repeater mode- while two of three modules are switched on and squelch is on.You have to press and hold -func, moni and ent- keys, then two blinking -L´s- will show up on the bottom off the display.When one of the two modules receives a signal strong enough to open the squelch this signal is immediately transmitted on theother module and vice versa.You stop the mode by pressing the buttons in the same manner as above and see the blinking -L´s- going away.73Walter, DH0KARThis modification is read 540 times.top of page09-12-2001(IC-F3/4) Icom F3/4 extended RX & TXAuthor: Jonathan Davis - jd865@uplink.net.MODIFICATION.NETWhile holding down the [C] + [Monitor] button turn on radio.Dealer will appear on LCD.Imput 159357.You can ch up or down and you will see the freq corresponding with each ch.Radio will promp to enter RX. Do so and push [#] to enter or again to del.