Digital Servo Amplifier SERVOSTAR 400 - BIBUS SK, sro

General 07/03 Kollmorgen
1.2 Use as directed
The servo amplifiers are components which are built into electrical equipment or machines, and can
only be commissioned as integral components of such equipment.
The manufacturer of the machine must produce a hazard analysis for the machine and
take appropriate measures to ensure that unforeseen movements do not result in personal
injury or material damage.
Use the servo amplifiers only on the following types of supply:
1 x 115V AC (only SERVOSTAR 40xM, unearthed operation is permissible)
3 x 115V AC (only SERVOSTAR 40xM, unearthed operation is permissible)
1 x 230V AC (only SERVOSTAR 40xM, unearthed operation is permissible)
3 x 230V AC (all types, unearthed operation is permissible)
3 x 400V AC (only SERVOSTAR 44xM, TN-system or TT-system with earthed
neutral point, max. 5000A symmetrical rated current)
If the servo amplifiers are used in residential areas, or in business or commercial premises, then
additional filter measures must be implemented by the user.
The SERVOSTAR 400 family of servo amplifiers is only intended to drive specific brushless synchronous
servomotors with closed-loop control of torque, speed and/or position. The rated voltage
of the motors must be at least as high as the DC-link voltage of the servo amplifier.
The servo amplifiers may only be operated in a closed switchgear cabinet, taking into account the
ambient conditions defined on Page 18. Ventilation or cooling measures may be required to keep
the temperature below 45°C.
Use only copper-cored cables for wiring. The conductor cross-sections can be taken from the European
standard EN 60204 (or Table 310-16 of NEC for 60°C or 75°C in the column for AWG
cross-sections).
We can only guarantee that the system will conform to the standards cited on Page 6 if the components
used are exclusively those supplied by us (servo amplifier, motor, cables etc.).
10 SERVOSTAR ® 400 Installation manual