Digital Servo Amplifier SERVOSTAR 400 - BIBUS SK, sro

Directives and Standards 07/03 Kollmorgen
European Directives and Standards
Servo amplifiers are components that are intended to be incorporated into electrical plant and machines for industrial
use.
When the servoamplifiers are built into machines or plant, the intended operation of the amplifier is forbidden
until it has been established that the machine or plant fulfills the requirements of the EC Machinery Directive
98/37/EG and the EC Directive on EMC (89/336/EEC).
To fulfill the EC Machinery directive (98/37/EG), the following standards have to be applied:
EN 60204-1 (Safety and electrical equipment of machines)
EN 292 (Safety of machines)
The manufacturer of the machine must produce a hazard analysis for the machine and take appropriate
measures to ensure that unforeseen movements do not result in personal injury or material damage.
To fulfill the Low Voltage Directive 73/23/EEC, the following standards have to be applied:
EN 60204-1 (Safety and electrical equipment of machines)
EN 50178 (Equipment of high voltage plant with electronic devices)
EN 60439-1 (Low-voltage switchgear and controlgear assemblies)
To fulfill the EC EMC regulations (89/336/EEC), the following standards have to be applied:
EN 61000-6-1 or EN 61000-6-2 (noise immunity within the domestic range/industrial range)
EN 61000-6-3 or EN 61000-6-4 (noise emission within the domestic range/industrial range)
The manufacturer of the machine or plant is responsible for ensuring that they meet the limits required by the
EMC regulations. Advice on the correct installation for EMC – such as shielding, grounding, arrangement of
connectors and cable routing – can be found in this documentation.
The machine / plant manufacturer must examine whether with its machine / plant still further or other
standards or EEC guidelines are to be used.
Conformity
Conformity with the EC Directive on EMC 89/336/EEC and the Low Voltage Directive 73/23/EEC is mandatory
for servoamplifiers supplied within the European Union.
To fulfill the EMC directive, the standard EN 61800-3 is applied.
In the reference to noise immunity the servoamplifier fulfills the requirement to the category second environment
(industrial environment).
For the range of the noise emission the rvo amplifier fulfills the requirement to a product of the category reduced
availability.
Warning!
This is a product with reduced availability according to IEC 61800-3. This product can cause interferences
within domestic range; if required you must accomplish appropriate measures.
The servo amplifiers have been tested by an authorized testing laboratory in a defined configuration with the
system components which are described in this documentation. Any divergence from the configuration and installation
described in this documentation means that you will be responsible for carrying out new measurements
to ensure that the regulatory requirements are fulfilled.
To fulfill the Low Voltage Directive, the standard EN 50178 has to be applied.
6 SERVOSTAR ® 400 Installation manual