Digital Servo Amplifier SERVOSTAR 400 - BIBUS SK, sro
Digital Servo Amplifier SERVOSTAR 400 - BIBUS SK, sro
Digital Servo Amplifier SERVOSTAR 400 - BIBUS SK, sro
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Kollmorgen 07/03 Installation<br />
2.4 Setup software<br />
2.4.1 General<br />
This chapter describes the installation of the setup software DRIVE.EXE for the <strong>SERVOSTAR</strong> <strong>400</strong><br />
digital servo amplifiers.<br />
We offer training and familiarization courses on request.<br />
2.4.1.1 Use as directed<br />
The operator software is intended to be used for altering and storing the operating parameters for<br />
the <strong>SERVOSTAR</strong> <strong>400</strong> series of servo amplifiers. The attached servo amplifier is commissioned with<br />
the assistance of the software - during this process the drive can be controlled directly by the service<br />
functions.<br />
Only professional personnel who have the relevant expertise described on Page 9 are<br />
permitted to carry out online parameter setting for a drive which is running.<br />
Sets of data which are stored on data media are not safe against unintended alteration<br />
by other persons. After loading a set of data you must therefore check all parameters<br />
thoroughly before enabling the servo amplifier.<br />
2.4.1.2 Software description<br />
The servo amplifiers must be adapted to the requirements of your installation. Usually you will not<br />
have to carry out this parameter setting yourself on the amplifier, but on a PC, with the assistance of<br />
the operator software. The PC is connected to the servo amplifier by a null-modem (serial) cable.<br />
The setup software provides the communication between the PC and <strong>SERVOSTAR</strong> <strong>400</strong>.<br />
You will find the setup software on the accompanying CD-ROM and in the download section of the<br />
Danaher Motion web appearance.<br />
With very little effort you can alter parameters and immediately observe the effect on the drive,<br />
since there is a continuous (online) connection to the amplifier. At the same time, important actual<br />
values are read out from the amplifier and displayed on the PC monitor (oscilloscope function).<br />
Any interface modules which may be built into the amplifier are automatically recognized, and the<br />
additional parameters which are required for position control or motion-block definition are made<br />
available.<br />
Sets of data can be stored on data media (archived) and loaded again. You can also print out the<br />
data sets.<br />
We provide you with motor-specific default sets of data for all the reasonable combinations of servo<br />
amplifier and motor. In most applications you will be able to use these default values to get your<br />
drive running without any problems.<br />
<strong>SERVOSTAR</strong> ® <strong>400</strong> Installation manual 35
Change language