Digital Servo Amplifier SERVOSTAR 400 - BIBUS SK, sro
Digital Servo Amplifier SERVOSTAR 400 - BIBUS SK, sro
Digital Servo Amplifier SERVOSTAR 400 - BIBUS SK, sro
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Kollmorgen 07/03 Interfaces<br />
3.5.3 <strong>Digital</strong> control outputs (X3)<br />
Technical characteristics<br />
— Ground reference is <strong>Digital</strong>-GND (DGND, terminal X1/4,5 on the master)<br />
— Alle digital outputs are floating<br />
— DIGITAL-OUT1 and 2 : Open-collector, max. 30V DC, 10mA<br />
<strong>SERVOSTAR</strong> <strong>400</strong><br />
Programmable digital outputs DIGITAL-OUT 1/2:<br />
You can use the digital outputs DIGITAL-OUT1 (terminal X3/8) and DIGITAL-OUT2<br />
(terminal X3/9) to output messages from pre-programmed functions that are stored in the servo<br />
amplifier.<br />
A list of the pre-programmed functions can be found in the Online Help.<br />
If an input is freshly assigned to a pre-programmed function, then the data set must be stored in the<br />
EEPROM of the servo amplifier, and the 24V auxiliary supply of the servo amplifier must be switched<br />
off and on again (to reset the amplifier software).<br />
<strong>SERVOSTAR</strong> ® <strong>400</strong> Installation manual 43
Change language