GPT-3000 SERIES - FLT Geosystems

8.2 Executing a LayoutThe following methods can be selected for executing a Layout:1) Recalling points from internal memory by point number.2) Direct key input of coordinate values.Example setting : Recalling point from internal memory.8 LAYOUTOperating procedure Operation DisplayLAYOUT 1/2F1:OCC.PT INPUTF2:BACKSIGHTF3:LAYOUT P↓1 Press the [F3](LAYOUT) key from the layout menu1/2.2 Press the [F1](INPUT) key, and enter PT#. *1)Press the [F4](ENT) key. *2)3 Enter reflector height in the same way.When the layout point is set, the instrument willstart layout calculation.HR: Calculated horizontal angle of the layout pointHD: Calculated horizontal distance from theinstrument to the layout point4 Collimate the prism, and press the [F1](ANGLE)key.PT#: Layout pointHR: Measured (Actual) horizontal angle.dHR: Horizontal angle to be turned to the layoutpoint = Actual horizontal angle - Calculatedhorizontal angle.Correct direction when dHR = 0°00'00"5 Press the [F1](DIST) key.HD: Measuring (Actual) horizontal distancedHD: Horizontal distance to be turned to thelayout point = Actual horizontal distance –Calculated horizontal distance.dZ: Vertical distance to be turned to the layoutpoint = Actual vertical distance – Calculatedvertical distance.6 Press the [F1](MODE) key.The fine mode measuring starts.[F3][F1]Enter PT#[F4][F1]Enter R.HT[F4]Collimate P[F1][F1][F1]LAYOUTPT#:INPUT LIST NEZ ENTERREFLECTOR HEIGHTINPUTR.HT : 0.000 mINPUT ––– ––– ENTERCALCULATEDHR= 90°10'20"HD= 123.456 mANGLE DIST ––– –––PT#: LP-100HR: 6°20'40"dHR: 23°40'20"DIST ––– NEZ –––HD*[t] < mdHD:mdZ:mMODE NEZ NP/P NEXTHD* 110.12 mdHD: –13.34 mdZ: –0.05 mMODE NEZ NP/P NEXTHD*[r] < mdHD:mdZ:mMODE NEZ NP/P NEXTHD* 120.129 mdHD: –3.327 mdZ: –0.046 mMODE NEZ NP/P NEXT8-9