GPT-3000 SERIES - FLT Geosystems

7 DATA COLLECTION*1) Refer to Section 2.6 “How to Enter Alphanumeric characters”.*2) PCODE can be input by inputting a register number linked with PCODE Library.To show the list of PCODE library, press the [F2](SRCH) key.*3) Data collect sequence can be set to [EDIT→MEAS]. See to Section 7.7 “Setting Parameter of DataCollect [CONFIG.]”.*4) The mark "*" indicates the previous measuring mode.*5) You can confirm the measured data as follows. Refer to Section 7.7 “Setting Parameter of Data Collect[CONFIG.]”.V : 90°10'20"HR: 120°30'40"SD: 98.765 m> OK ? [YES][NO]7.2.1 Searching the recorded dataWhile executing the DATA COLLECT mode, you can search the recorded data.Operating procedure Operation DisplayPT# →PT-02PCODE :R.HT : 1.200 mINPUT SRCH MEAS ALL1 While executing the DATA COLLECT mode, press[F2](SRCH) key. *1)The using file name will appear on the top of theright side of the display.2 Select one of three search methods by pressing[F1] to [F3] key. *2)[F2][F1] to [F3]SEARCH [TOPCON]F1:FIRST DATAF2:LAST DATAF3:PT# DATA*1) It is possible to see the PCODE list when the arrow is located beside PCODE or ID.*2) The operation is same as the "SEARCH" in the MEMORY MANAGER mode.For more information, refer to Section 9.2 “Searching Data”.7.2.2 Entering PCODE / ID using PCODE LibraryWhile executing the DATA COLLECT mode, you can enter PCODE /ID from PCODE Library.Operating procedure Operation DisplayPT# :PT-02PCODE →R.HT : 1.200 mINPUT SRCH MEAS ALL1 Move the arrow to the PCODE or ID in the DATACOLLECT mode, press the [F1](INPUT) key.2 Enter a register number linked with PCODE libraryand press the [F4](ENT) key.(Example)Register number, 32 = TOPCON[F1]Enter No[F4]PT# :PT-02PCODE =32R.HT : 1.200 m1234 5678 90.– [ENT]PT# :PT-02PCODE :TOPCONR.HT → 1.200 mINPUT SRCH MEAS ALL7-8