GPT-3000 SERIES - FLT Geosystems

17 CHECK AND ADJUSTMENT14 Press the [F4](SET) key. Repeat the procedures instep 13 and 14 so that the count of measuredtimes matches to the one in FACE(2).Then the display returns to main menu.COMPLETE●To show the constant list of systematic error ofinstrumentADJUSTMENT MODE 1/2F1:V ANGLE 0 POINTF2:INST. CONSTANTF3:V0 AXIS P↓1 Press the [F3] key from Adjustment Mode menu 1/2.[F3]V0 AXISF1:MEASUREMENTF2:CONSTANT LIST2 Press the [F2] key.Correction values are displayed.3 Press the [F1] key.The display returns to previous menu.[F2][F1]VCo: -1°57'12"HCo: -0°00'20"HAx: -0°00'20"EXIT*1) It is able to get the average value from 1 to 10 measurements. To get the average, repeat theprocedures in steps 5, 6 or 10, 11. The measured times is counted in the second line of display.*2) The compensation values of 1) Error of vertical axis (X,Y tilt sensor offset), 2) Collimation error, and 3)Error of vertical angle 0datum will be set and memorized internally.*3) The operating procedure steps to set compensation value of 4) Error of horizontal axis.*4) Pressing the [F1](SKIP) key enables to set next step without changing the last compensated value.*5) Pressing the [F1](SKIP) key makes end of setting without changing compensation value.17.6 EDM Alignment Checking modeThis mode is used for check the optical axis and EDM axis. For more information about the checking,see Section 17.2.1“Checking the optical axis of EDM and theodolite” .Operating procedure Operation Display1 While pressing the [F1] key, turn power switch ON. [F1]+Power ON2 Press the [F4] key. [F4]ADJUSTMENT MODE 1/2F1:V ANGLE 0 POINTF2:INST. CONSTANTF3:V0 AXIS P↓ADJUSTMENT MODE 2/2F1:EDM CHECKP↓3 Press the [F1] key.EDM checking mode will display.[F1]V: 90° 10'10"HR: 20° 00'20"SIGNAL:[❙ ❙ ❙ ❙ ❙]EXIT NP/P HOLD17-16