GPT-3000 SERIES - FLT Geosystems

5.2 Setting Height of the Instrument5 COORDINATE MEASUREMENTIt is possible to retain the height of instrument after turning the power off. Refer to Chapter 16“SELECTING MODE”.Operating procedure Operation Display1 Press the [F4](↓) key from the coordinatemeasurement mode to get the function on page 2.2 Press the [F2](INSHT) key.The current value is displayed.5.3 Setting Height of Target (Prism Height)This mode can be used to obtain Z coordinate values . It is possible to retain the height of target afterturning the power off. Refer to Chapter 16 “SELECTING MODE”.[F4][F2]3 Enter the instrument height. *1) [F1]Enter Inst.HT[F4]*1) Refer to Section 2.6 “How to Enter Alphanumeric characters”.● Input range –999.9999 < Instrument height < +999.9999 m–999.999 < Instrument height +999.999 < ft.–999.11.7 < Instrument height < +999.11.7 ft.+inchOperating procedure Operation Display1 Press the [F4](↓) key from the coordinatemeasurement mode to get the function on page 2.2 Press the [F1](R.HT) key.The current value is displayed.[F4][F1]3 Enter the prism height. *1) [F1]Enter R. HT[F4]*1) Refer to Section 2.6 “How to Enter Alphanumeric characters”.● Input range –999.9999 < Prism height < +999.9999 m–999.999 < Prism height +999.999 < ft.–999.11.7 < Prism height < +999.11.7 ft.+inchN: 123.456 mE: 34.567 mZ: 78.912 mMEAS MODE NP/P P1↓R.HT INSHT OCC P2↓INSTRUMENT HEIGHTINPUTINS.HT: 0.000 mINPUT ––– ––– ENTER1234 5678 90. –[ENT]N: 123.456 mE: 34.567 mZ: 78.912 mMEAS MODE NP/P P1↓N: 123.456 mE: 34.567 mZ: 78.912 mMEAS MODE NP/P P1↓R.HT INSHT OCC P2↓REFLECTOR HEIGHTINPUTR.HT: 0.000 mINPUT ––– ––– ENTER1234 5678 90. –[ENT]N: 123.456 mE: 34.567 mZ: 78.912 mMEAS MODE NP/P P1↓5-2