GPT-3000 SERIES - FLT Geosystems

9.2 Searching Data9 MEMORY MANAGER MODEThis mode is used to search the recorded file data in the DATA COLLECT or LAYOUT mode.The following 3 search methods in each type of files can be selected.1: First data search2: Last data search3: Point number search(MEAS.DATA, COORD.DATA)Number search (PCODE LIB.)MEAS. DATA : Measured data in the data collect mode.COORD. DATA : Coordinate data for layout, control points and new point data measured in thelayout mode.PCODE LIB. : The data which was registered with a number from 1 to 50 in Point code library.Point name (PT#, BS#) , ID, PCODE and Height data (INS.HT, R.HT) can be corrected in the searchingmode.Measured value can not be corrected.9.2.1 Measured Data SearchingExample :Point number searchingOperating procedure Operation Display1 Press the [F3](MEMORY MGR.) key from the[F3] MEMORY MGR. 1/3menu 1/3.F1:FILE STATUSF2:SEARCHF3:FILE MAINTAN P↓2 Press the [F2](SEARCH) key. [F2]3 Press the [F1](MEAS. DATA) key. [F1]SEARCHF1:MEAS. DATAF2:COORD. DATAF3:PCODE LIB.SELECT A FILEFN:_________4 Press the [F1](INPUT) key and enter File Name.Press the [F4](ENT) key. *1),2)[F1]Enter FN[F4]INPUT LIST ––– ENTERMEAS. DATA SEARCHF1:FIRST DATAF2:LAST DATAF3:PT# DATA5 Press the [F3](PT# DATA) key. [F3]PT# DATA SEARCHPT#:_________6 Press the [F1](INPUT) key and enter PT#.Press the [F4](ENT) key. *1)7 Press the [F4](↓) key to scroll data for selectedpoint.[F1]Enter PT#[F4][F4]INPUT ––– ––– ENTERPT#⎦TOP-104 1/2V ⎦ 98°36'20"HR⎦ 160°40'20"TILT⎦ 0°00'00" ↓PT#⎦TOP-104 2/2PCODE⎦R.HT⎦ 1.200 mEDIT↓*1) Refer to Section 2.6 "How to enter alphanumeric characters".*2) To show the file list, press the [F2](LIST) key.● "⎦ " represents data shown on the display is the stored data.● Press the [ ]or[ ] key to scroll to next or previous point.● To search MEAS. DATA of the same point number, press[ ]or[ ] key.9-3