GPT-3000 SERIES - FLT Geosystems

Laser Safety● Distance MeasurementGPT-3000 series uses the invisible laser beam. The GPT-3000 series are manufactured and sold inaccordance with "Performance Standards for Light-Emitting Products" (FDA/BRH 21 CFR 1040) or"Radiation Safety of Laser Products, Equipment Classification, Requirements and User`s Guide" (IECPublication 825) provided on the safety standard for laser beam.As per the said standard, the GPT-3000 series is classified as "Class 1 (l) Laser Products".In case of any failure, do not disassemble the instrument. Contact TOPCON or your TOPCON dealer.● Laser pointer and Plumb Laser (Plumb laser is supplied for certain markets)GPT-3000 series plumb laser and laser pointer use the visible laser beam. The GPT-3000 series plumblaser and laser pointer are manufactured and sold in accordance with "Performance Standards forLight-Emitting Products" (FDA/BRH 21 CFR 1040) or "Radiation Safety of Laser Products, EquipmentClassification, Requirements and User`s Guide" (IEC Publication 825) provided on the safety standardfor laser beam.As per the said standard, the GPT-3000 series plumb laser type is classified as "Class 2 (II) LaserProducts".In case of any failure, do not disassemble the instrument. Contact TOPCON or your TOPCON dealer.LabelsFind the labels which describes the caution and safety about the laser beam as follows in GPT-3000series.We request you to replace it one anytime the caution labels are damaged or lost and paste a new oneat the same place. You can get the labels from Topcon or your dealer.Warning LabelLaser apertureExplanatory LabelCAUTIONLASER RADIATIONDO NOTSTARE INTO BEAMWAVE LENGTH 620nm-690nm1mW MAXIMUM OUTPUTCLASS II LASER PRODUCTAperture LabelAVOID EXPOSURELASER LIGHT IS EMITTEDFROM THIS APERTURELaser aperture(Only for laser plummet type.)LASER RADIATIONDO NOT STARE INTO BEAMMaximum output 1 W @ Wave length 690nm CWCLASS 2 @LASER PRODUCTSymbol mark while the laser is emitting.The following symbol mark will appear at theright side of the second line.TILT SENSOR:[XY-ON]X:-0°00'25"Y: 0°00'20"X-ON XY-ON OFF L.PLSymbol mark5