GPT-3000 SERIES - FLT Geosystems

7 DATA COLLECTION7.1.2 Selecting a Coordinate File for Data CollectionWhen coordinate data in a coordinate data file are used for occupied point or backsight point, select acoordinate file from the data collect menu 2/2 beforehand.Operating procedure Operation DisplayDATA COLLECT 2/2F1:SELECT A FILEF2:PCODE INPUTF3:CONFIG. P↓1 Press the [F1](SELECT A FILE) key from DATACOLLECT menu 2/2.[F1]SELECT A FILEF1:MEAS.DATAF2:COORD.DATA2 Press the [F2](COORD.DATA) key. [F2]SELECT A FILEFN:INPUT LIST --- ENTER3 Select a coordinate file in the same manner asSection 7.1.1 “Selecting a File for Data Collection”.7.1.3 Occupied Point and Backsight PointThe occupied point and direction angle in the data collect mode are linked with the occupied point anddirection angle in normal coordinate measurement.It is possible to set or change the occupied point and direction angle from the data collect mode.Occupied point can be set by two setting methods as follow.1) Setting from the coordinate data stored in the internal memory.2) Direct key input.The following three setting methods for backsight point can be selected.1) Setting from the coordinate data stored in the internal memory.2) Direct key input of coordinate data.3) Direct key input of setting angle.Note: See 9.4 “Coordinate Data Direct Key Input” and 9.7.2 “Loading Data” for how to storecoordinate into the internal memory.●Example for setting the occupied point:In case of setting occupied point from the coordinate data stored in the internal memory.Operating procedure Operation Display1 Press the [F1](OCC.PT# INPUT) key from the [F1] PT# →PT-01data collect menu 1/2.ID :The previous data is shown.INS.HT: 0.000 mINPUT SRCH REC OCNEZ2 Press the [F4] (OCNEZ) key. [F4]OCC.PTPT#:PT-013 Press the [F1](INPUT) key and enter PT#.*1)Press the [F4](ENT) key.[F1]Enter PT#[F4]INPUT LIST NEZ ENTERN: 0.000mE: 0.000mZ: 0.000m>OK? [YES] [NO]7-4