UAD Powered Plug-Ins Manual v5.2 - Just Music

UAD–Xpander Pre-Flight Check
1. Ensure UAD Powered Plug-Ins v4.7.1 (or higher) is already installed (see
“UAD Software Installation” on page 24).
2. Ensure both the host computer and UAD–Xpander are powered off.
3. Ensure the UAD–Xpander is properly connected (see “Xpander Connections”
on page 105).
UAD–Xpander Startup Sequence
1. Turn on the UAD–Xpander power switch on the rear of the unit. The UA
logo glows red, indicating UAD–Xpander power is on but is not electrically
connected to the computer.
2. Boot the computer. The UA logo glows blue, indicating an electrical connection
has been established with the computer.
3. – (Windows) The UAD drivers are installed automatically by the New Hardware
Wizard during the first boot following initial software installation.
– (Mac) The UAD drivers are loaded during boot.
4. You can confirm UAD driver communication is established by using the
UAD Performance Meter. See “Using the UAD Performance Meter to Check
Installation” in the QuickStart.pdf.
The UAD–Xpander startup sequence is complete.
Using
UAD–Xpander
After the UAD–Xpander is installed and powered up properly with the computer
system (see “Startup Sequence” on page 106), the UAD Powered
Plug-Ins software is ready to be used. Refer to other chapters in this manual for
software operating instructions.
Note: All UAD–Xpander operations (except for hardware setup and startup
sequence) are identical to the UAD-1/UAD-1e/UAD-2 cards.
Power Indicator
When power is applied to the UAD–Xpander via the rear switch, the UA logo
on the front panel glows. The color of the logo indicates the power state
• When UAD–Xpander power is on but there is no electrical connection to the
computer (such as when the computer is off), the UA logo glows red.
UAD Powered Plug-Ins Manual - 107 - Chapter 10: UAD-Xpander & UAD-Xtenda