UAD Powered Plug-Ins Manual v5.2 - Just Music

Adjusting Gain
Adjusting Gain
and cF
Adjusting Gain
and Bandwidth
Adjusting xF
The gain of a band can be adjusted by click-dragging
the top of its colored line. In this case the cursor
changes to an up/down arrow when hovered over
the hot spot to indicate the direction available for
dragging.
If the cursor is moved slightly lower than the above example,
the gain and center frequency can be adjusted
simultaneously, without adjusting the bandwidth.
In this case the cursor changes to an
up/down/left/right arrow when hovered over the hot
spot to indicate the direction available for dragging.
If the cursor is moved to the upper-left region of the
three center bands (LMF, MF, HMF), the gain and
bandwidth can be adjusted simultaneously, without
changing the center frequency. In this case the cursor
changes to a diagonal arrow when hovered over the
hot spot to indicate the direction available for dragging.
If the cursor is moved to where two bands crossover,
the crossover frequencies can be adjusted, without
changing the gain or center frequency. In this case
the cursor changes to a left/right arrow when hovered
over the hot spot to indicate the direction available
for dragging.
Note: Frequencies can also be adjusted by using the Frequency Value parameters
(see“Frequency Values” on page 139).
UAD Powered Plug-Ins Manual - 138 - Chapter 14: Precision Multiband