UAD Powered Plug-Ins Manual v5.2 - Just Music

Trem/Fade Module
Figure 127. The Trem/Fade module
Trem/Fade is a sophisticated envelope-controlled modulation processor that
can produce classic tremolo, fade, and other gain modulation effects. Tremolo
is achieved by modulating the amplitude (volume) of a signal with a low
frequency oscillator (LFO). Trem/Fade includes some new modes such as
Shimmer and VariTrem that enable the production of new volume effects.
Sync Button
Threshold
(Thresh) Knob
This button puts the plug-in into Tempo Sync mode. See Chapter 8, “Tempo
Sync” for more information.
Sets the threshold level for the Trem/Fade effect. When the signal level exceeds
the threshold, the Trem/Fade effect is triggered. The range is 0dB to
-80dB.
Note: When Trem/Fade is used within the complete Nigel plug-in, the threshold
detector is connected to the output of the Gate module. This allows for optimal
level tracking independent of the amplifier and other effect settings.
Once a Trem/Fade effect is instigated by crossing the threshold level, the effect
will continue until the signal drops below the Threshold level. For example,
if a signal is faded in, the signal won’t fade in again until its level drops
below the Threshold value.
Trigger LED
The Trigger LED indicates when the Trem/Fade input signal is above the
Threshold. It provides visual feedback for optimizing the Threshold setting.
The Trigger LED glows bright red when the signal is above the Threshold
value.
UAD Powered Plug-Ins Manual - 343 - Chapter 38: Nigel