16.03.2014 Views

UAD Powered Plug-Ins Manual v5.2 - Just Music

UAD Powered Plug-Ins Manual v5.2 - Just Music

UAD Powered Plug-Ins Manual v5.2 - Just Music

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

If the LFO Type menu is set to one of the Trem modes, the Rate is linked to the<br />

Trem/Fade module rate. In this scenario the Rate knob value changes to<br />

“Trem”, adjusting the Mod Delay Rate will have no effect, and the modulation<br />

rate is determined by the Trem/Fade module settings (even if the Trem/Fade<br />

module is disabled with the On/Off button).<br />

Depth & Time/<br />

Sweep Knobs<br />

Sweep Knobs<br />

The function and label of the second and third controls in the Mod Delay module<br />

are determined by the Mode pull-down menu. When the Mod Delay<br />

Mode is set to Flanger, the second and third knobs are labeled Sweep Lo and<br />

Sweep Hi respectively. When the Mod Delay Mode is set to Chorus or Vibrato,<br />

the second and third knobs are labeled Depth and Time respectively.<br />

The Sweep knobs determine the frequency range that will be affected by the<br />

Mod Delay. The low and high frequency values can be independently adjusted.<br />

This flexible arrangement allows the Mod Delay to affect a narrow or<br />

broad frequency range, and also enables you to tune the frequency response<br />

characteristic to match the signal if desired.<br />

Note: The Sweep knobs are only visible in Flanger mode.<br />

Sweep Lo Knob<br />

Sets the lowest frequency to be affected by the Mod Delay. The available<br />

range is from 100Hz to 6000Hz.<br />

Because the Sweep Lo frequency cannot be set higher than the Sweep Hi frequency,<br />

if the Lo value is increased beyond the Hi value the Hi value will increase<br />

to match the Lo value.<br />

Sweep Hi Knob<br />

Sets the highest frequency to be affected by the Mod Delay. The available<br />

range is from 100Hz to 6000Hz.<br />

Because the Sweep Hi frequency cannot be set lower than the Sweep Lo frequency,<br />

if the Hi value is decreased below the Lo value the Lo value will decrease<br />

to match the Hi value.<br />

Depth Knob<br />

Sets the amount of modulation to be applied to the signal. The maximum<br />

available range is 0 to 300 cents. However, the available range is dependent<br />

on the Rate setting. Less Depth range is available is slower Rate settings.<br />

Note: The Depth knob is only visible in Chorus and Vibrato modes.<br />

<strong>UAD</strong> <strong>Powered</strong> <strong>Plug</strong>-<strong>Ins</strong> <strong>Manual</strong> - 347 - Chapter 38: Nigel

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!