UAD Powered Plug-Ins Manual v5.2 - Just Music

Cabinet On/Off
Button
Output Level
Meter
Enables or disables the Cabinet module within Preflex. The Cabinet is engaged
when the button indicator is bright red. You can use this switch to compare
the Cabinet settings to that of the original signal or bypass the entire
Cabinet section to reduce UAD DSP load.
This LED-style VU meter displays the level of the signal at the output of the Cabinet.
Just before the red ‘LED’ is illuminated, the signal is at 0dB. In order to
avoid overloading your host application signal path, adjust the Preflex output
level so that the signal is at or below 0dB.
Phasor Module
The Phasor is a frequency-variable comb-filter with low frequency oscillator
modulation. It is capable of producing dramatic sweeping and swooshing effects,
including modern and classic sounds such as those produced by the
Mutron Bi-Phase, Small Stone and MXR series of phasors.
Figure 124. The Phasor plug-in window
Sync Button
Rate Knob
Sweep Knobs
This button puts the plug-in into Tempo Sync mode. See Chapter 8, “Tempo
Sync” for more information.
Sets the LFO modulation (sweep) rate of the Phasor. The available range is
from 0.03Hz to 10Hz.
The Sweep knobs determine the frequency range that will be affected by the
Phasor. The low and high frequency values can be independently adjusted.
This flexible arrangement allows the Phasor to affect a narrow or broad frequency
range, and also enables you to tune the frequency response characteristic
to match the signal if desired.
UAD Powered Plug-Ins Manual - 335 - Chapter 38: Nigel