UAD Powered Plug-Ins Manual v5.2 - Just Music

ER End control
bat (time &
amplitude)
Bypass
switch
ER Start control
bat (predelay &
amplitude)
Materials
Filtering
control bat
Late-field
relative timing
display
Figure 103. DreamVerb Reflections panel
Bypass
Reflections Start
Reflections End
Filtering
The early reflections can be disabled with this switch. When the switch is off
(black instead of grey), the other Reflections controls have no effect. This
switch has no effect on the direct signal path.
This bat controls two early reflections start parameters. Dragging the bat horizontally
controls the ER predelay (the delay between the dry signal and the
onset of the ER). Dragging it vertically controls the amplitude of the reflections
energy at the ER start time.
This bat controls two ER end point parameters. Dragging the bat horizontally
controls the ER end time (the time at which the ER is no longer heard). Dragging
it vertically controls the amplitude of the reflections energy at the end
point.
This parameter determines the amount of filtering from the Materials panel to
be applied to the early reflections. The Materials effect upon the ER is most
pronounced when Filtering is set 100%.
Note: The parameters in the Materials panel have no effect on the early reflections
unless this parameter value is above 0%.
UAD Powered Plug-Ins Manual - 281 - Chapter 32: DreamVerb