UAD Powered Plug-Ins Manual v5.2 - Just Music

Recirculation allows both positive and negative values. The polarity refers to
the phase of the delays as compared to the original signal. If Recirculation displays
a positive value, all the delays will be in phase with the source. If it displays
a negative value, then the phase of the delays flips back and forth between
in phase and out of phase.
Damping Knob
Wet/Dry Mix
Knob
This low pass filter reduces the amount of high frequencies in the signal. Turn
down this control to reduce the brightness. Higher values yield a brighter signal.
Damping also mimics air absorption, or high frequency rolloff inherent in
tape-based delay systems.
This control determines the balance between the delayed and original signal.
Values greater than 50% emphasize the wet signal, and values less than 50%
emphasize the dry signal.
Wet/Dry Mix allows both positive and negative values. The polarity refers to
the phase of the delays as compared to the original signal. If a positive value
is displayed, then all the delays will be in phase with the source. With a negative
value, the delayed signal is flipped 180 degrees out of phase with the
source.
L-Pan Knob
R-Pan Knob
Enable/Bypass
Switch
Sets the stereo position for the left channel, allowing you to adjust the width
or balance of the stereo signal. For a mono signal, set both the L-Pan and R-
Pan to the left.
Sets the stereo position for the right channel, allowing you to adjust the width
or balance of the stereo signal. For a mono signal, set both the L-Pan and R-
Pan to the left.
Enables or disables the Reflection Engine. You can use this switch to compare
the RS-1 settings to that of the original signal or bypass the entire RS-1 section
to reduce UAD DSP load.
Output Knob
Adjusts the relative output of the plug-in.
UAD Powered Plug-Ins Manual - 194 - Chapter 20: CS-1 Channel Strip